Methods of cleaning the washing machine of the machine against mold, scale and soap deposits.
Contents
- How do I clean the washing machine from the smell?
- How do I clean the washing machine of mold?
- Than to clean the washing machine the automatic device from a scum?
- How do I clean the washing machine with citric acid?
- How do I clean the soda?
- How do I clean it with white?
- How do I clean the gum in the washing machine?
- How do I clean the drain hose in a washing machine?
- How do I clean the drain filter in a washing machine?
- How do I clean the washing machine with Amway bleach?
- VIDEO: Cleaning the washing machine against mold
Washing machine is the favorite assistant of every woman. Even with proper use, this appliance requires periodic cleaning. The main source of contamination is hard water and detergents.
How to clean the washing machine from the smell?
The smell in the washing machine is formed due to the use of substandard detergents. Usually in this case the soap is not completely washed off the walls of the drum. It covers a thin layer of the inner parts of the drum and provokes the process of rotting and fungus formation.
To wash soapy coating, it is enough to use any washing powder with the inscription "automatic" and turn on the washing mode at 90-95 ° С.You do not need to put linen in the drum. Cleaning is carried out every 6 months. After cleaning, the door and the rubber band are wiped dry. The door is left open at the same time.
How do I clean the washing machine from mold?
Mold in the washing machine appears due to the frequent use of the washing regime in a gentle mode at low temperature. Powders with bleach and high temperature destroy mold, so in this mode you must also wash. First, look at where the mold accumulates. Usually it can be found in the powder compartment, behind the sealing rubber and in the drain hose. Remove these parts and rub them with a brush and soap. Soak in the means of mold, which can be purchased at a hardware store.
Instructions for removal of mold from the drum:
- Fill the powder compartment with a liter of whiteness
- Turn on the machine for washing at the highest temperature. This is approximately 90-95 ° C
- When the door of the machine heats up as much as possible, turn off or pause the
- device. It is necessary that the solution in the drum is 1.5-2 hours.
- Then turn on the water drain and rinse
- . Pour in a liter of vinegar of
- into the air conditioner compartmentAfter the washing is over, turn on the rinse again, but do not add anything to the machine
. How do I clean the washing machine of scale?
For this you can use folk remedies or special chemistry against scale. The easiest way is to get rid of the scale using Angtanakipin. It is a powder that contains aggressive substances, which when dissolved in water form a solution capable of dissolving calcium and magnesium salts.
It is these salts that are the scum. After that, the wash mode without laundry is switched on. In this case, do not fall asleep too much powder, otherwise you risk ruining rubber gaskets and the machine "will flow."
Experienced masters recommend adding Kalgon during each wash. It softens water and prevents the formation of scale.
But many housewives do not purchase this product because of the high cost, which often leads to the failure of the heating element.
How do I clean the washing machine with citric acid?
Citric acid is the most inexpensive and safe way to deal with deposits of scale. Carrying out the cleaning every 3-4 months, you will significantly extend the life of the device. At the same time, citric acid does not harm sealing rubber bands and plastic parts of the device.
Instructions for cleaning the washing machine with citric acid:
- Fill 60-100 g of the product into the powder compartment and turn on the full washing mode at 60 ° C.
- It is necessary for the machine to complete the entire rinsing cycle with
- rinsing. If the machine has not been cleaned for a long time, take 100 g of acid and turn on the wash at maximum temperature
How to clean soda?
Soda is used to clean the appliance from mold. Usually it accumulates behind a rubber sealant. There are traces of fungus and on the compartment for washing powder. To clean the machine of mold, mix ordinary drinking soda with water in a ratio of 1: 1.Saturate the cloth with this solution and wipe the drum, the rubber band and the powder tray. This remedy gently and easily disposes of the machine from the fungus.
How to clean white?
Whiteness - effectively clean the washing machine of mold and soap deposits. You need to pour a liter of money into the drum and turn on the longest mode at a high temperature. This is 95 ° C, the machine should be very hot, but you must have time to rinse.
Set the device to pause for 1 hour. Then continue washing. After the end of the cycle, switch the unit to "Fast" mode at 30 ° C.This cycle will remove the whiteness.
Remember, you can not load any items into the drum when cleaning.
How to clean the rubber band in the washing machine?
Cuff, or rubber band - a seal between the door and the drum. It prevents the outflow of water during washing. If the elementary rules of care are not complied with, mold and plaque accumulates on this site.
For cleaning, we recommend the use of whiteness, domestos or a solution of copper sulfate. You need to soak the solution with a cloth and wipe the rubber band. After such cleaning, it is desirable to wash the unit with warm water.
To prevent mold formation, adhere to the rules:
- After washing, dump the remaining water from the groove in the
- seal. Leave the door ajar
- . Clean the seal with
- from time to time. Clean the